Description:
...IOCHRDY from IOR or IOW or from BALE: When low, DM9008 will pull IOCHRDY low afterthe command strobe. If high, IOCHRDY will be pulled low after BALE goes high5 BUSERR Bus Error: This bit shows that DM9008 has detected an ISA bus error. This bit will be high ifDM9008 inserts wait states into a system access and the system terminates the cycle without... ...F2H CONFIG C R Direct mapping of the CONFIG C register, page 2F4H RESET CSN W Writing bit 2 to 1 will reset DM9008 CSN to 0DM9008ISA/Plug & Play Super Ethernet Contoller... ...DM9008 provides an LED driver in pin 55. When the DM9008is in transmission or receive mode, this pin will go low for80ms, then into high impedance state for 50ms to indicate thepresence of traffic on the network. In idle state, it is in high...